Installation of belt conveyor frame should be from the beginning

Installation of belt conveyor frame should be from the beginning

Stainless steel roller supplier shares that equipment belt conveyor frame of the equipment is from the beginning of the beginning frame, and then the middle frame of each section of the equipment, and finally installed the tail frame. Before the equipment frame, the first thing is to pull up the Central Line in the whole length of the conveyor, because it is an important condition for the normal operation of the conveyor belt to insist that the Central Line of the conveyor is on the same line.

So in the equipment of each frame, it is necessary to align with the center line, also want to put shelves together leveling, the frame to the center of the error, per meter long is 0.1mm.

Device driver device. When the equipment drives the equipment, it is necessary to pay attention to make the belt conveyor's transmission shaft and the belt conveyor's center line straight, so that the width of the center of the driving drum and the conveyor's center line coincidence, the reducer's axis and the transmission axis parallel. Together, all axles and rollers should be leveled. Axis horizontal error, according to the width of the conveyor, allow in the range of 0.5-1.5mm.

That's all for the sharing,and we supply High Quality Stainless steel roller for sale, if you have any demand for our products,just feel free to contact us.